> Zubehör>Moai accessories

Filter

Preis

37 - 64 €

Moai accessories  

Es gibt 8 Artikel.
Zeige 1 - 8 von 8 Artikeln
  • Made of acrylic, this resin vat is designed for Moai SLA printer from Peopoly. With a layer of PDMS at the bottom, it has a capacity of 4L.This vat is also compatible with Form1 and Form1+.

  • Especially for Moai SLS Printer, the build plate is a single piece made of anodized aluminum and rubber knob. It ensure an excellent rigidity and durability. Key features:Weight: 200g Color: Silver Compatible only with Moai

  • Moai's new film based vat design provides greater durability and ease of use than the traditional PDMS based vat. Includes 3 metal pieces vat assembly, 1 acrylic tensioner, and 1 FEP film.  Order extra FEP films when ordering this vat.

  • This Heater module for the Peopol Moai is designed to keep the internal chamber over 25C.  It is sensor controlled and comes with its own power supply separate from the Moai printer.

  • The best module for simple levelling of your Moai 3D printer, this easy-to-level build plate is full metal and designed to use with both FEP and PDMS vat. TO USE: Simply loosen the 4 screws on the build plate, lower it to the vat and then tighten the screws up. It's as easy as that. 

  • Replacement FEP film sheets for your Moai Kit. With an upgrade FEP VAT on your Moai, les resin will stick and save your materials and keep operation costs low. Simply replace film as needed.

  • The Peopoly UV Curing Light is a UV LED for the cure of 3D printed resin parts. Those 6 high power UV LED speed up post-processing by curing 5cm of resin within 10 seconds only. Solidify photosensitive resin quickly and efficiently with the Peopoly UV Curing Light.Due to the intensity of UV light output, the user must wear eye protection or their...

  • Peopoly's Tough resin is designed to be durable and withstand most wear and tear of functional parts. Despite being a tough resin, before curing prints can be slightly softer and therefore may require a higher printing temperatur above 25C and more supports. Peopoly recommends that prints be cured at least 30 minutes of post-curing via UV light with...

Zeige 1 - 8 von 8 Artikeln