> The Lounge     Printing     STARTT lead screw replacement
lead screw replacement
 STARTT   Started by John Lehman   2017-06-27 15:07:02 +01:00   Comments: 4    Viewed: 868

  1. John Lehman
    John Lehman Member
    One of the lead screws that goes into the 3D Printed Part is not screwing in properly.  Feels like it's cross threaded (or whatever term is appropriate for a lead screw).   Rather than wait for one to be shipped from the UK, I thought I would order one locally or online.   Does anyone know the specs for this - I know the length, but diameter, thread pitch, etc?
    John Lehman, 2017-06-27 15:07:02 +01:00
  2. Jack Keum
    Jack Keum Moderator Staff Member
    Hi John, I just replied your email moment ago.
    Jack Keum, 2017-06-27 15:08:46 +01:00
  3. John Lehman
    John Lehman Member





    Jack, The reply did not come through.   Could you reply to john@johnlehman.com.   thanks.
    John Lehman, 2017-06-27 15:32:29 +01:00
  4. Jack Keum
    Jack Keum Moderator Staff Member





    Please check again later. 
    Jack Keum, 2017-06-27 15:51:09 +01:00
  5. (You must log in or sign up to post here)

Report Post

Write your reason

Log in | Sign up
Terms & Conditions!
Help!