> The Lounge     Printing     STARTT x axis
x axis
 STARTT   Started by Michael Boileau   2017-09-18 00:45:14 +01:00   Comments: 3    Viewed: 1090

  1. Suddenly my x axis won't home. Doesn't matter if I use 'home all' or 'home x axis, all it does is go to the opposite side, the right, hits it a few times and just sits there. If I use 'home all', everything works except the x axis. Any idea why?
    Michael Boileau, 2017-09-18 00:45:14 +01:00
  2. John Bartram
    John Bartram Member
    Hi Michael, I am having the exact same issue. I installed the latest Cura and Firmware yesterday hoping it would overcome the problem, but it didn't. Have you had any feedback from imakr? I intend to contact them today to try and find a resolution, I'll let you know the results. John
    John Bartram, 2017-09-20 09:21:08 +01:00
  3. John Bartram
    John Bartram Member
    Just to let you know, imakr advised me to switch the X & Y motors over and re-try, which I did with no change to the result.
    I'll let you know when they come up with a solution. - John
    John Bartram, 2017-09-20 16:53:09 +01:00
  4. (You must log in or sign up to post here)

Report Post

Write your reason

Log in | Sign up
Terms & Conditions!
Help!