> The Lounge     Printing     STARTT Filament not heating
Filament not heating
 STARTT   Started by Richard whitehouse   2018-01-02 17:53:31 +00:00   Comments: 2    Viewed: 759

  1. When downloading designs from Myminifactory. in some case the filament heats to normal temperature.
    Some design don't heat the filament and the temperature stays at about 35C. Any suggestions?
    Richard whitehouse, 2018-01-02 17:53:31 +00:00
  2. Stupid question Richard, but are you setting the temp in your slicer? The stl file you have downloaded may not be set to the right settings for your filament. Sorry if you've tried this
    Verity Gregory, 2018-01-02 20:05:49 +00:00
  3. (You must log in or sign up to post here)

Report Post

Write your reason

Log in | Sign up
Terms & Conditions!
Help!