> The Lounge     Printing     STARTT X-axis motor doesn't turn
X-axis motor doesn't turn
 STARTT   Started by Sabrina Xie   2018-01-06 02:08:50 +00:00   Comments: 4    Viewed: 1118

  1. Sabrina Xie
    Sabrina Xie Member
    When I press "Home All," instead of turning, the x-axis motor just makes a sort of humming noise and doesn't move the hot end at all.
    I've tried to tighten the pulley only to find that the actual center rod thing in the motor isn't turning either, so I don't think it's because of any slack or a loose pulley. I've also detached and reattached the connector to no avail. The other two axes home fine, and it was working fine before, too, before suddenly stopping.
    Does anyone know what the issue might be?
    Sabrina Xie, 2018-01-06 02:08:50 +00:00
  2. I'm having the same problem. I assembled the startt/tronxy xy 100 and tried to callibrate it. After selecting "Home All" the printhead moved down, the printbed moved backwards. Only the printhead movement to the right doesnt. It makes some noise like described above. Any solutions for that?
    Oliver Oliver, 2018-04-15 09:55:10 +01:00
  3. Hello, I study at the geographical faculty and duddenly I was required to write an abstract on those subject, which is not going to be useful in my life furtherly. What to do in this case, because there is absolutely no time? Should I order it on various services like https://writingcreek.com/freelance-writing-jobs-new-york/ will they write everything correctly?
    Kromer hromer, 2019-04-24 09:25:33 +01:00
  4. Sam Tyler
    Sam Tyler Member
    Sam Tyler, 2019-05-06 03:05:15 +01:00
  5. (You must log in or sign up to post here)

Report Post

Write your reason

Log in | Sign up
Terms & Conditions!