- Extruder with screw control
- 2 grey needles: 1.2mm
- 2 red needls: 0.4mm
- Aluminum tank
- Tank support
- Pressure regulator
- 10 kg of Porcelain
- SD card with g-code and settings
Compressor is not included.
WASP certifies the use of the LDM extruder with ceramic material, so the use of other kind of mixture or materials as to be considered as not covered by the technical support and warranty.
The use of the LDM WASP extruder has been tested and guaranteed only on WASPprinters, warranty and assistance will be made at discretion of the manufacturer(WASP) in case the system is used on other printers.
The Manufacturer and iMakr declines all liability for injury to persons and damage to
components due to an incorrect use of the product.
|Printing Technology||Fused Filament Fabrication|