Forside

  • Show Sidebar

Aktive filtre

Sinterit ATEX Vacuum Cleaner + Separator

21.396,00 kr.

Speed up and optimise your sintering workflow and keep your workspace clean with the ATEX and Intertek certified Vacuum Cleaner from Sinterit. This compact cleaner can quickly remove up to 99% of unused powder from your SLS printer so you can minimise powder change times and maximise your printing output. Includes a complete set of accessories for vacuuming your printer, and your workspace.

Includes Free Shipping.

Apium F300 Filamenttørrer

19.408,00 kr.

The Apium F300 is a filament dryer for high performance materials, such as PVA, PA, PP, ABS, PEI, PPSU, PEEK. The dryer significantly increases the success rate of prints through pre-dried filament.

Sinterit Platform

2.596,00 kr.

The Platform by Sinterit is specially designed to place your Lisa or Lisa Pro SLS 3D printer at the ideal height for easy access and features a rigid design, two height settings and lockable wheels.

Free Shipping Included.

Sinterit PA12 Smooth SLS-pulver 2kg (frisk)

1.976,00 kr.

A high-quality general purpose PA12 Nylon powder for use with the Sinterit Lisa and Lisa Pro SLS 3D printers. The new V2 version has a lower refresh ratio of 26%. This is virgin powder which is used to refresh the properties of used powder.

Includes Free Shipping.

Peopoly Moai - Heater Module

412,00 kr.

This Heater module for the Peopol Moai is designed to keep the internal chamber over 25C.  It is sensor controlled and comes with its own power supply separate from the Moai printer.

Sinterit Sandblaster STD

3.896,00 kr.

The Sandblaster is designed for cleaning, polishing and finishing prints, using dry abrasive material. Using compressed air and small glass balls, the Sandblaster allows to check every nooks of your model and thus highlight each detail.

 * Does not include an air compressor.

Sinterit PA12 Smooth SLS-pulver 6kg (frisk)

5.396,00 kr.

PA12 Smooth Fresh is a general purpose Nylon powder that is specially selected for use with the Sinterit Lisa and Lisa Pro SLS 3D printers. This is virgin powder which is used to refresh the properties of used powder. This new V2 version has a lower refresh ratio of 26%.

Includes Free Shipping.

Sinterit Studio Open for Lisa

Sinterit Studio Open 2019 offers the same functionalities of standard Sinterit Studio, but you also gain access to adjust the printing parameters. Sinterit Studio Open enables you to use some 3rd party materials or experiment with printing settings.