Accessories by Brand

Add additional functionality to your 3D printing or 3D scanning set-up with accessories designed to improve your 3D printing, 3D scanning and processing experience and streamline your workflow.

  • Show Sidebar

Active filters

Nexa3D xCURE Post-Curing Unit

The xCURE from Nexa3D is the perfect post-curing solution to ensure you achieve optimum material properties. Designed to cure an entire build volume from the Nexa3D NXE 400 in one go. Featuring three curing modes; UV only, Heat only and UV + Heat and pre-set individual resin curing profiles, the Nexa3D xCURE is the perfect solution for post curing your parts.

Zortrax Apoller Smart Vapor Smoothing

€6,359.00

Automatic post-processing with the Zortrax desktop smart vapor smoothing device. Achieve the look of an injection moulded part from your FDM prints with the industrial performance. Smart Vapor Smoothing technology evenly smooths out all surfaces including all complex geometries and interlocking or movable parts. Ideal for small to medium production runs.

NK-Optik - Otoflash G171

€2,598.00

The Otoflash G171 is used for curing of light-curable resins through light-induced photopolymerization. It is optimised for quick curing of medical grade 3D Printed materials using Nitrogen. Featuring two bottom mounted flash lamps operating at 10 flashes per second, it is ideal for curing otoplasties and hearing aids.

3ntr VENTO

The VENTO drying unit by 3ntr prevents filament damage caused by humidity, storing polymers in the perfect environment for performance.

Nexa3D xWASH Post-Processing Unit

Nexa3D xWASH is a post-processing washing station designed specifically to clean resin parts from the Nexa3D NXE 400. You can wash two entire build volumes simultaneously thanks to the xWASH large capacity. Choose to wash your parts while still attached to the build volume or as individual parts in the basket. With a simple, user friendly interface to help set parameters such as timer length, agitation speed and direction, the Nexa3D xWASH is a powerful and consistent part washing solution.

Loctite 3D Printing EQ CL36 LED Cure Chamber

€7,200.00

The Loctite 3D Printing EQ CL36 LED Cure Chamber is a high performance LED system for curing UV resins. Featuring multidirectional 405nm UV light and a rotating turntable for uniform curing. Designed to achieve optimal results and finish for all engineering resins. 

3ntr STORM

Complete your 3ntr 3D printing experience with STORM, designed to hold up to 3 VENTO units and a 3ntr HEPA/VOC filtering unit for a safer printing environment. 

Zortrax Cleaning Station

€3,828.00

Zortrax Cleaning Station is a device made to remove excessive, unsolidified resin from the model’s surfaces. The entire cleaning process lasts for about 5 minutes and is fully automated.

Apium F300 3D Filament Dryer

€2,499.00

The Apium F300 is a filament dryer for high performance materials, such as PVA, PA, PP, ABS, PEI, PPSU, PEEK. The dryer significantly increases the success rate of prints through pre-dried filament.